Retract™

R200	R300
R450	R600

	The patented double wishbone retracting movement allows the thruster's turbine to move along a perfectly vertical axis. This in turn makes for simple and small hull openings. Models from R300 up use a gas spring that constantly hold the thruster shut tight. Even in cases of hydraulic system failure the Retract would snap shut rather than fall open.
	Using a unique & patented folding movement, Retract™ thruster units require little space inside the yacht thereby allowing designers to freely use all the interior space available. Fully water resistant, the Retract™ can be installed in the bottom of damp sail lockers or wet bilges without problem.
	The Retract's™ unique design means that the thruster not only has a longer stroke(s) but also uses a much smaller hull opening when compared to swing type designs.
	Built-in weak zones in the Retract's™ mechanism assure hull integrity in case of accidents such as fowling ground lines or anchor chains.
	The Retract™ mechanism allows the last closing movement of the door to be completely vertical. This in turn allows the use of a flexible gasket in the hull rebate. Often used on high performance vessels, the pounding forces submitted to the hulls plating in the bow sections can be violent. Retract™ thrusters use silent block mountings between the hull door & the thruster's turbine to ensure long-term structural integrity.

R200